Using the machine
Two step presser foot lifter with integrated front foot lift
To raise the presser foot, lift the presser foot lever on the rear of the machine,
until it engages (A). It can be raised again to the maximum height and held in
this position to provide more space between presser foot and stitch plate (B).
When the foot is raised A and B, the front of the foot is automatically lifted.
Note:
When the presser foot is raised, all the tensions are released making it easier
to thread the machine.
Changing the presser foot
Switch the machine o (power switch”O”)
• Raise the presser foot.
• Turn handwheel towards you until needles are fully raised. Match the match-
ing up marks on handwheel and side cover.
Press the catch (C) to release the presser foot from the clamp. Raise the press-
er foot shank to the highest position (B) and remove the presser foot to the
left. To attach the presser foot, place it under the shaft. The groove in the shaft
should line up exactly with the presser foot pin (D). Lower the shank and the
presser foot will engage automatically.
(E) Standard foot
(F) Cover stitch presser foot
Adjusting the presser foot (G)
When making seams on swim, gymwear or similar material, this with the cover-
stitch, shift the lever to the rear, presser foot pressure on L.
For normal use shift the lever to the front side.
C
D
A
B
E
F
G
WARNING :
When using the extra lift (B), do not run the machine or turn the hand-
wheel.
10
To Next Page
Loading...
