Using the machine
Inserting the needles
Needles can be inserted quickly and easily with the practical needle
inserter (A).
Switch the machine o (power switch ”O”)
Disconnect machine from electricity supply.
Turn handwheel towards you until needles are fully raised. Match the
matching up marks on handwheel and side cover.
Lower the presser foot.
Using the small screwdriver, loosen the needle setscrews and remove
the needles (B).
Place the right-hand needle, flat side towards the back, into the hole
of the needle inserter and insert the needle as far as possible into the
needle clamp. Tighten the setscrew lightly and then insert the left-hand
needle in the same way and tighten both setscrews (C).
A
C
B
12
To Next Page
Loading...
