Preparing the machine / Using the machine
Thread stand
Push the support rod firmly into the socket on the back of the ma-
chine.
Raise the support rod (C) fully, turning slightly until the position
catches engage. Position the thread guide (D) on the thread stand
so that the arrow is to the front.
Placing the spool holder for the chain thread
Lift the foam pad (A), slide the guide tabs (C) of the spool holder (B)
into the guide of the upper side of the spool holder from left to right
into position (E) and press until tab (D) clicks into the underside of
rib. (F)
C
D
D
C
A
B
F
E
D
C
F
E
8
To Next Page
Loading...
