JUKI MO-80CB - Spool Cap; Removal and Replacement of Chip Box; Replacement; Removal

Spool cap
Chapeau de bobine
Tapa del carrete
Thread spool
Bobine de fil
Carrete
Press in
Poussez sur la broche
Presionar
1
2
27
9. HOW TO OPEN AND CLOSE LOOPER
COVER
(1) OPEN LOOPER COVER
* Push the looper cover to the right as far as it will
go.
* Pull looper cover down toward you.
(2) CLOSE LOOPER COVER
* First pull the looper cover upward and then slide it
to the left until it locks.
Note : The looper cover has a safety switch and
the machine will not sew if the looper cover
is open.
8. REMOVAL AND REPLACEMENT OF
CHIP BOX
(1) REPLACEMENT
* Position the machine so the front is nearly
aligned with the edge of the table.
* Insert the chip box under the looper cover. Be
sure the left side of chip box is mounted near the
cutter where the scraps drop.
(2) REMOVAL
* To remove, hold the chip box as shown and pull it
outward.
(3) SPOOL CAP
* When using a regular thread spool, fit the spool
cap supplied with the machine onto the thread
spool as shown at right.
Be sure to turn off power switch.
Assurez-vous que le couvercle de
boucleur est fermé lors d'une couture.
2
1