JUKI MO-80CB - To Thread Thread Upper Looper (Blue)

3
5
4
37
Be sure to turn off power switch.
* Thread the thread guide A (2) by pulling the thread
towards the left until it slips under guide.
Then pull thread along the path as illustrated.
* While holding thread with fingers, pass it between
the tension discs and pull thread down to make
certain it is properly located in between the
tension discs (3).
Thread the upper looper as indicated (1)~(8).
* Raise Presser foot to release tension discs.
* Pass thread from back to the front through the
thread guide (1).
(1) TO THREAD THREAD UPPER LOOPER
(BLUE)
1
3
2
2
3
2
3
1
4
7
8
5
6