15. STANDARD OVERLOCK AND ROLLED
HEM STITCHING
(1) TO SEW STANDARD OVERLOCK
* Set seam width selection lever to N to move seam
width claw to standard overlock sewing position.
Note : Be sure to push seam width selection lever as
far as it will go in the direction of setting N.
(2) TO SEW ROLLED HEM
* Set seam width selection lever to R to retract the
seam width claw and set it for rolled hem.
Note : Be sure to push seam width selection lever as
far as it will go in the direction of setting R.
35
* Thread the machine in the order (1) to (4) as
shown at right.
Note : Threads go through the take-up lever cover
for Overlock as shown.
Tip : Your new machine is threaded to sew a
standard overlock. Tie your own threads to
these threads and carefully pull them through
the machine, to easily thread your new
overlock machine the first time.
Note : If the lower looper should come unthreaded,
do the following :
(1) Unthread the needle(s)
(2) Thread the lower looper
(3) Thread the needle(s)
16. GENERAL THREADING INFORMATION
3
2
4
1
To Next Page
Loading...
