JUKI MO-80CB - To Thread Overedge Right Needle; Thread (Green) (B on Needle Clamp)

3
5
4
2
2
* Thread the thread guideA(2) by pulling the thread
towards the left until it slips under guide.
Then pull thread along the path as illustrated.
* Pass thread from back to the front through the
thread guide (1).
* While holding thread with finger, pass it between
the tension discs and pull thread down to make
certain it is properly located in between the
tension discs (3).
(3) TO THREAD OVERLOCK RIGHT NEEDLE
THREAD (GREEN) (B ON NEEDLE CLAMP)
* Thread the right needle as indicated (1)~(9).
* Raise presser foot to release tension discs.
43
3
4
5
6
7
8
9
1
2
3
3
1