* Continue to thread points (4)~(9).
* Slip the thread into the rear slot on the thread
guide (5) and into the slot on the take-up lever
cover (6). Then slip the thread into the right slot
on the thread guide (7).
* Before threading the eye of the needle, make sure
thread is behind the thread guide located on the
bottom of the needle clamp (8).
* Thread the eye of the needle. Use the needle
threader ( 49) to make needle eye threadingpage
easier.
* Pull about 10 cm (4") of thread through needle eye
to hang free.
* Place the thread to the back, under the presser
foot.
(4) TO THREAD THREAD LEFT NEEDLE
(YELLOW)
45
4
6
8
9
5
7
1
3
4
5
6
7
8
9
1
2
1
* Thread the left needle as indicated (1)~(9).
* Raise Presser foot to release Tension discs.
* Pass thread from back to the front through the
thread guide (1).
7
5
To Next Page
Loading...
