3
5
4
41
* Turn the hand wheel toward you until the lower
looper extends out 5~10mm from the stitch plate
edge.
* Thread the looper area of the machine following
the red color coded thread guides (4)~(8).
Note : Use tweezers provided in the accessory case
to aid in threading the looper.
* While holding thread with finger, pass it between
the tension discs and pull thread down to make
certain it is properly located in between the
tension discs (3).
* Place the thread with the point of the tweezers
slightly from right and to the left of threading guide
(4).
* Continue threading through guides (5)-(6).
* To thread the last thread guide (7), pull about 10
cm (4") of thread through guide (8).
Hint : Moving the selection lever to R makes the
threading easier. Remember to set it back to N
before starting to sew.
* Thread the looper eye (8) from front to back using
the tweezers. Make sure the thread runs into the
āVā cutouts (A) on threader lever. Firmly hold the
thread tail with your left hand and pull the threader
lever (B) up into place and back to snap the
thread into thread guide (7).
3
3
7
8
6
8
4
5
6
7
4
5
7
8
B
7
B
A
To Next Page
Loading...
