– 14 –
❹
❸
❺
❶
III. FOR THE OPERATOR
1. Operating procedure of the sewing machine
1) Press ON button
❶
of the power switch to turn ON
the power.
(Caution) If the power indicator LED on the panel
does not light up after having turned ON
the power switch, immediately turn OFF the
power switch and check the supply voltage.
In addition, in such a case as this, re-turn
ON the power switch when 2 to 3 minutes
or more have passed after turning OFF the
power switch.
2) When the needle bar is not in UP position, it auto-
matically turns to the UP position.
(Caution) When turning ON the power for the rst
time, there is the case where the timing is
slightly retarded to perform the initializa-
tion work. When turning ON the power, the
needle bar moves. Do not put your hands or
things under the needle.
PFL KFL
Presser foot operation by pedal Enabled Disabled
Pedal depressing depth for thread trimming Deep Shallow
3) The pedal is operated in the following four steps:
a. The machine runs at low sewing speed when you
lightly depress the front part of the pedal.
❸
b. The machine runs at high sewing speed when you
further depress the front part of the pedal.
❸
(If the automatic reverse feed stitching has been
preset, the machine runs at high speed after it com-
pletes reverse feed stitching.)
c. The machine stops (with its needle up or down)
when you reset the pedal to its original position.
d. The machine trims threads when you fully depress
the back part of the pedal.
❺
* When the auto-lifer (AK device) is used, one more operating switch is provided between the sewing machine
stop switch and thread trimming switch. The presser foot goes up when you lightly depress the back part of the
pedal
❹
, and if you further depress the back part
❺
, the thread trimmer is actuated.
When starting sewing from the state that the presser foot has been lifted with the Auto-lifter and you depress
the back part of the pedal, the presser foot only comes down.
• If you reset the pedal to its neutral position during the automatic reverse feed stitching at seam start, the ma-
chine stops after it completes the reverse feed stitching.
• The machine will perform normal thread trimming even if you depress the back part of the pedal immediately
following high or low speed sewing.
• The machine will completely perform thread trimming even if you reset the pedal to its neutral position immedi-
ately after the machine started thread trimming action.
To Next Page
Loading...
Need help?
General
