– 23 –
❻
❺❹❸
❼
❻
❺❹❸
❼
❻
❺❹❸
❼
Ⓑ
Ⓐ
Ⓓ
Ⓔ
Ⓒ
Ⓑ
Ⓐ
Ⓓ
Ⓒ
Ⓑ
Ⓐ
Ⓓ
Ⓒ
Ⓔ
Ⓔ
6. Setting of functions of SC-920
Functions can be selected and specied.
(Caution) For the function setting procedure of any operation panel other than CP-18, refer to the Instruction
Manual for the operation panel to be used.
1) Turn ON the power with switch
❼
held pressed.
(The item which has been changed
during the previous work is displayed.)
* If the screen display does not change,
re-carry out operation described in
step 1).
(Caution)
Be sure to re-turn ON the power
switch when one or more seconds
have passed after turning it OFF. If
the power switch is re-turned ON
immediately after turning it OFF, the
sewing machine may fail to operate
normally. In such a case, be sure
to turn ON the power switch again
properly.
2) To move the setting No. forward, press
switch
❹
. To move the setting
No. backward, press
switch
❸
.
(Caution)
If the setting No. is moved forward
(or backward), the previous (or sub-
sequent) content of the setting is
conrmed. Be careful when the con-
tent of a setting is changed (when
the
/
switch is touched).
Example)
Changing the maximum number of revolu-
tions (setting No. 96)
Press switch
❸
or switch
❹
to call setting No. "96."
The current set value is displayed on
indicator
Ⓑ
.
Press switch
❺
to change the
setting to "2500."
* The content of setting of the setting No. returns to the initial value by pressing switch
❺
and
switch
❻
simultaneously.
3)
After completion of the changing procedure, press switch
❸
or
switch
❹
to conrm the updated value.
(Caution) If the power is turned OFF before carrying out this procedure, the changed content is not updated.
When switch
❸
is pressed, the display on the panel changes to the previous setting No. When
switch
❹
is pressed, the display on the panel changes to the subsequent setting No. After com-
pletion of the operation, the machine is returned to the normal sewing state by turning OFF the power
and re-turning it ON.
To Next Page
Loading...
Need help?
General
