Julabo CORIO CD-B13 - Connect the Device to the Power Supply; Connect Bridge Mounted or Heating Circulator

Initial operation
37
7.2 Connect the device to the power supply
7.2.1 Connect bridge mounted or heating circulator
This section describes how the circulator is connected as a bridge mounted
circulator or heating circulator.
 The circulator is mounted as a bridge mounted or heating circulator.
 The power cable is ready for use. If using the 200-230 V, 50/60 Hz variant in
the United States or Canada, you must use the JULABO power cable USA
3x12AWG (order number 7.901.2694). This power cord is not included.
1. Insert the power cable on the back of the circulator into the mains
connection [1].
2. Connect the circulator to the power supply using the power cable.
 The circulator is connected.