4
7 Initial operation ................................................................................. 36
7.1 Mounting the circulator .................................................................. 36
7.1.1 Mount heating or refrigerated circulator ................................... 36
7.2 Connect the device to the power supply ....................................... 37
7.2.1 Connect bridge mounted or heating circulator ......................... 37
7.2.2 Connect refrigerated circulator ................................................. 38
7.3 Connecting an external system ..................................................... 39
7.3.1 Connect an external system with screw connections .............. 40
7.3.2 Connect an external system with barbed fittings...................... 42
7.4 Set high temperature safety function ............................................. 43
7.5 Fill device ....................................................................................... 44
7.6 Set up power supply for the refrigerated circulator ....................... 44
7.7 Adjusting the flow of the bath fluid ................................................. 45
7.8 Set chiller mode ............................................................................. 46
7.9 Set temperature warning limits ...................................................... 46
8 Operation ........................................................................................... 48
8.1 Switch on the unit .......................................................................... 48
8.2 Switch off the unit .......................................................................... 48
8.3 Configuring setpoint temperature .................................................. 48
8.4 Start temperature control application ............................................ 49
8.5 Activate autostart function ............................................................. 49
8.6 Record data ................................................................................... 50
8.6.1 Record measurement data ....................................................... 50
8.6.2 Reading out blackbox data ....................................................... 50
8.7 Adjust pump ................................................................................... 51
8.8 Remote control device ................................................................... 51
8.8.1 Remote control device using USB interface ............................. 51
8.8.2 Set RS232 interface parameters .............................................. 52
8.8.3 Remote control device using RS232 interface ......................... 53
8.8.4 Request device status .............................................................. 53
8.9 Setting the timer ............................................................................ 54
8.10 Adjusting the temperature sensor (ATC) ....................................... 55
8.10.1 Adjust internal temperature sensor .......................................... 55
8.10.2 Enabling ATC function .............................................................. 56
8.11 Device Reset ................................................................................. 56
To Next Page
Loading...
