EasyManuals Logo

Jungheinrich EJD 220 User Manual

Jungheinrich EJD 220
226 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #109 background imageLoading...
Page #109 background image
8.2.4 Changing the Set-up Code
Z
To change the length of the master code you must follow the procedure in "Choose
length of the new master code (4-6 digit) and add user codes", see page 116. If
there are still user codes stored in the code lock, the master code to be changed
must be the same length as the saved user codes.
Requirements
To prepare the truck for operation, see page 106.
Procedure
Press the O key (78).
Enter the valid master code with the digit keys.
When you enter the valid master code the LED
(77) flashes green.
Enter the parameters 0-0-0 with the digit keys.
Confirm with the SET key (76).
The LEDs (73,77) flash green.
Enter the valid master code again with the digit keys.
Confirm with the SET key (76).
The LEDs (74,77) flash green.
Enter the valid master code with the digit keys.
Z
The new master code must be different from existing user codes.
Confirm with the SET key (76).
The LEDs (75,77) flash green.
Enter the new master code again with the digit keys.
Confirm with the SET key (76).
Wait until the LED (77) flashes green. The setting is saved.
Press the O key (78).
The truck is switched off and the LED (77) is lit red.
Check the new master code:
Switch on the truck with the new master code, see page 106
When you enter the valid master code the LED (77) flashes green.
Press the O key (78).
The truck is switched off and the LED (77) is lit red.
76
73
74
75
78
77
107
04.19 en-GB

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Jungheinrich EJD 220 and is the answer not in the manual?

Jungheinrich EJD 220 Specifications

General IconGeneral
BrandJungheinrich
ModelEJD 220
CategoryForklifts
LanguageEnglish

Related product manuals