0602.GB
E 10
Driving
f
When swivelling the driver’s standing platform (16) upwards, do not reach between
the driver’s standing platform and the truck’s side wall.
There are three different travelling modes:
– Pedestrian-controlled operation:
Swivel the safety extensions (17)*
)
inwards and then fold up
driver platform (16).
– Ride-on mode:
Fold down driver platform (16).
– Ride-on mode with increased speed:
Swivel the safety extensions (17)*
)
outwards and then fold down
driver platform (16).
A
The travelling function is blocked if the driver is not standing on the platform and the
safety extensions* are not folded out.
*
)
not with vehicles with load bearing capacity of 1200kg
f
Do not drive the truck unless the hoods are closed and locked in the stipulated man-
ner. When passing through swing doors, or similar, take care that the anti-collision
button (1) is not inadvertently operated.
– Start up the truck (refer to section 3).
– Swivel the control shaft (4) into driving range “F”.
– Turn the controller (8) in the desired travelling direction: forward (V) or reverse (R).
The truck will move in the selected direction.
A
The travelling speed is controlled by means of the controller (8).
R
R
V
V
F
B
B
8
4
17
16
0602.GB
E 10
Driving
f
When swivelling the driver’s standing platform (16) upwards, do not reach between
the driver’s standing platform and the truck’s side wall.
There are three different travelling modes:
– Pedestrian-controlled operation:
Swivel the safety extensions (17)*
)
inwards and then fold up
driver platform (16).
– Ride-on mode:
Fold down driver platform (16).
– Ride-on mode with increased speed:
Swivel the safety extensions (17)*
)
outwards and then fold down
driver platform (16).
A
The travelling function is blocked if the driver is not standing on the platform and the
safety extensions* are not folded out.
*
)
not with vehicles with load bearing capacity of 1200kg
f
Do not drive the truck unless the hoods are closed and locked in the stipulated man-
ner. When passing through swing doors, or similar, take care that the anti-collision
button (1) is not inadvertently operated.
– Start up the truck (refer to section 3).
– Swivel the control shaft (4) into driving range “F”.
– Turn the controller (8) in the desired travelling direction: forward (V) or reverse (R).
The truck will move in the selected direction.
A
The travelling speed is controlled by means of the controller (8).
R
R
V
V
F
B
B
8
4
17
16
To Next Page
Loading...
