To Next Page

To Previous Page

0602.GB

E 20

6.4 Keys

o-key (25)

The o-key (25) is always active and has the highest priority. It is used to set the truck

from any state to the basic state (truck switched off and not ready for operation) and

vice versa. It is exclusively used for switching off or resetting the truck.

Set key (21)

No function for the operator. In master mode, the entered values are confirmed by the

Set key.

Numeric keys

Keys 1, 2, 3, 4, 5, 6, 7, 8, 9, 0 are used for entering codes.

6.5 Master mode

Parameter changes must be made carefully and only by trained personnel. Changing

the parameters results in changed travel behaviour of the truck.

Changes are only saved when DIL switch no. 8 on the controller is set to “ON”.

To enter the master mode, the following is required:

– o-key (if in operating mode),

– enter master code.

Enter a parameter number and confirm with Set key (21).

If an invalid input is entered (LED (20) flashes red) you return to the basic state of the

master mode by actuating Set key (21). Enter a new parameter number and confirm

with Set key (21).

The following example show the setting of the acceleration parameter (parameter

101) in the travel programme.

Display instrument

(CANDIS)

LED (20) LED (22) LED (23) LED (24)

Operating hours

are indicated

284.9

green

flashing

off off off