EasyManuals Logo

Jungheinrich TFG 425s User Manual

Jungheinrich TFG 425s
229 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #130 background imageLoading...
Page #130 background image
129
03.13 EN
6.2 Assistance systems
The Access, Drive and Lift Control systems help the driver operate the truck with
regard to safety regulations, see "Safety regulations for truck operation" on page 74
of the present operating instructions.
Travel conduct
The operator must adapt the travel speed to local conditions. The truck must be driven
at slow speed when negotiating bends or narrow passageways, when passing
through swing doors and at blind spots. The operator must always observe an
adequate braking distance between the forklift truck and the vehicle in front and must
be in control of the truck at all times. Abrupt stopping (except in emergencies), rapid
U turns and overtaking at dangerous or blind spots are not permitted. Do not lean out
or reach beyond the working and operating area.
6.2.1 Access Control
The truck is only released for operation if:
1)The operator is seated.
2)The truck is switched on via the key switch (ISM o / CanCode o).
3)He is wearing the seat belt.
Z If the driver vacates the seat for a short while and the truck is not in the "neutral lock"
position (see "Travel" on page 81), the truck can be operated again when he returns
(seat occupied) and puts the seat belt back on again, without having to apply the
key switch again.
Z If travel is not enabled, the seat switch indicator lights up (98). Items 1 to 3 must be
performed again in the order listed.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Jungheinrich TFG 425s and is the answer not in the manual?

Jungheinrich TFG 425s Specifications

General IconGeneral
BrandJungheinrich
ModelTFG 425s
CategoryForklifts
LanguageEnglish

Related product manuals