03.13 EN
168
4.6 Replacing wheels
WARNING!
A truck tipover can cause accidents
In order to raise the truck, use only suitable lifting gear at the points specially provided
for this purpose.
XNote the weight of the truck on the data plate.
XAlways use a jack with a minimum capacity of 5000 kg kg.
XRaise the unladen truck on a level surface.
XWhen raising the truck, take appropriate measures to prevent it from slipping or
tipping over (e.g. wedges, wooden blocks).
WARNING!
Falling wheels can cause injury
XThe wheels of the truck are very heavy. A single wheel can weigh up to 150 kg.
XAlways replace wheels with a suitable tool and protective equipment.
Dismantle the wheels
Requirements
– Prepare the truck for maintenance and repairs
(see "Preparing the truck for maintenance and
repairs" on page 163).
Tools and Material Required
–Jack
– Hard wooden blocks
– Mounting lever
– Torque wrench
Procedure
• Place the jack against the contact point.
Z Jack contact point, see "Identification points and data plates" on page 30.
• Raise the truck.
• Support the truck with hard wooden blocks.
• Undo the wheel attachment (208).
• Disassemble the wheel, using a suitable mounting lever if necessary.
The wheel is now disassembled.
208
To Next Page
Loading...
Need help?
General
