03.13 EN
208
10.2 Customer service
10.2.1 Standard equipment
Brakes W A B C
1 Test brakes. t
Electrical System W A B C
1
Test warning and safety devices in accordance with operating
instructions.
t
2 Test displays and controls. t
3 Test the panel switch and check for damage. t
4 Test Emergency Disconnect switch. t
5 Check contactors and/or relays. t
6 Check fuse ratings. t
7
Check electric wiring for damage (insulation damage, connections).
Make sure wire connections are secure.
t
Power Supply W A B C
1 Check fuel system, tank and lines for leaks and damage. t
2
Check battery cable connections are secure, grease terminals if
necessary.
t
3 Check battery and battery components. t
4 Check battery voltage. t
Travel W A B C
1 Test exhaust system and check for leaks and damage. t
2 Check the wheel motor attachments. t
3
Check the wheel motors and displacement pump for noise and
leakage.
t
4
Check that hydraulic ports, hose and pipe lines are secure, check for
leaks and damage.
t
5 Test anti-freeze, top up if necessary. t
6 Replace radiator fluid and anti-freeze. t
7 Check cooling system for leaks. t
8 Check coolant level and top up if necessary. t
9 Test hydraulic fans and check for leaks. t
10 Check and clean radiator. t
11 Check tyre air pressure and top up if necessary. t
12 Check wheels for wear and damage. t
13 Check wheel suspension and attachment. t
14 Test starter and generator, Check wires and attachment. t
15 Check the low pressure circuit suction filter. t
16 Replace fuel filter. t
To Next Page
Loading...
Need help?
General
