To Next Page

To Previous Page

CAUTION: Avoid bending ber-opc cable beyond its minimum bend radius. An arc

smaller than a few inches in diameter can damage the cable and cause problems that

are dicult to diagnose.

CAUTION: Do not let ber-opc cable hang free from the connector. Do not allow

fastened loops of cable to dangle, which stresses the cable at the fastening point.

Step 5: Connect Power to the ACX Series Router

IN THIS SECTION

Connect AC Power to an AC-Powered ACX1100 Router | 12

Connect DC Power to a DC-Powered ACX1000 or ACX1100 Router | 13

Depending on your conguraon, your router uses either AC or DC power supplies. Perform the

appropriate procedures for each power supply in your router.

WARNING: You must ground the router before connecng the power cables.

Connect AC Power to an AC-Powered ACX1100 Router

To connect power to the AC-powered router, you need the following tools:

• AC power cords

1. Locate power cords that have a plug appropriate for your geographical locaon. For more

informaon, see the

ACX1000 and ACX1100 Universal Access Routers Hardware Guide

Juniper ACX1000 Quick Start

Other manuals for Juniper ACX1000