3. Position the device in its designated location in the equipment rack. Make sure the holes of the mounting
brackets align evenly with the holes of the equipment rack on both sides.
4. Starting at the bottom of the device, secure the device in the equipment rack by using the 10-32 x 3/8
Phillips screws. Have a third person do this for the larger and heavier CTP chassis.
5. Connect the necessary cables. (See “Cabling the CTP150 Platform Overview” on page 69 for instructions
about installing the cables.)
RELATED DOCUMENTATION
Before You Install the CTP150 Platform | 59
Installing the CTP150 Platform in Freestanding Mode | 60
Cabling the CTP150 Platform Overview | 69
61
To Next Page
Loading...
Need help?
General
