8. Tighten the module's captive screws using a Phillips screwdriver.
NOTE: Tighten the captive screws completely before installing an adjacent module so
that proper electromagnetic interference (EMI) gasket compression occurs. Failure to do
this can make it difficult to install adjacent modules.
9. Go to Cabling the CTP2000 Platform Overview.
RELATED DOCUMENTATION
Removing a CTP Interface Module, Processor Module, or Clock Module | 66
CTP2000 T1/E1 Interface Module
CTP2000 Clock Interface Modules
Cabling the CTP2000 Platform Overview
T1/E1 Interface Module Pinouts
Removing a CTP Interface Module, Processor Module, or Clock Module
NOTE: We recommend that you issue the slot disable command from the CLI before removing
a line module.
CAUTION: If you do not use the halt command before powering down the CTP device,
the CompactFlash card might become corrupted.
To remove a CTP module:
1. Issue the halt command.
2. Ground yourself by using an antistatic wrist strap or other device, and connect it to an ESD grounding
jack, if available, or another grounding device.
66
To Next Page
Loading...
Need help?
General
