Juniper CTP Series Hardware Guide

CHAPTER 15
Powering On and Initially Configuring the CTP150
Device
IN THIS CHAPTER
Before You Power On the CTP150 Device | 79
Powering On and Initially Configuring the CTP150 Device | 80
Powering Off the CTP Platform | 83
Before You Power On the CTP150 Device
Before powering on the device, make sure you complete the following tasks. See the appropriate sections
for information about these tasks.
WARNING: Be sure the power source is turned off and the device is turned off before
you perform the installation tasks.
•
Installing a CTP Interface Module, Processor Module, or Clock Module on page 65
•
Setting Up Management Access to the CTP150 Platform on page 75
RELATED DOCUMENTATION
Powering On the CTP150 Device | 80
Powering Off the CTP Platform | 83
79

Juniper CTP Series Specifications

General

Brand	Juniper
Model	CTP Series
Category	Server
Language	English