•
Stop bits: 1
•
Flow control: Xon/Xoff
7. Click OK.
RELATED DOCUMENTATION
Setting Up Management Access to the CTP150 Platform | 75
Connecting Directly to the CTP150 Platform | 75
Using SSH to Access the CTP Platform
When you have configured an IP address for the CTP150 device, you can run SSH from a remote host to
access the device through its Ethernet port. To connect the Ethernet port to the network:
1. Connect an Ethernet RJ-45 cable to one of the two Ethernet ports on the front panel of the CTP150
chassis.
2. Connect the other end of the cable to the appropriate Ethernet network for an out-of-band connection.
CAUTION: Do not change the IP address for the Ethernet interface that you are using
to communicate with the device. If you change the address, you will lose the SSH
session.
RELATED DOCUMENTATION
Setting Up Management Access to the CTP150 Platform | 75
77
To Next Page
Loading...
Need help?
General
