Juniper CTP2000 Series - Install PMC Module

To Next Page

To Previous Page

To remove and reinstall the CompactFlash card for the CTP2000 series devices with the

PP310 and PP332 processors:

1. Power off the unit.

2. Remove the RTM by unscrewing the retaining screws and pushing the extractors

outward with the latching buttons depressed.

3. Verify that the CompactFlash card is installed.

4. Remove the CompactFlash card–retaining screw and nut. You can then remove or

install the CompactFlash card in the flash socket.

5. Reinstall the CompactFlash card–retaining screw and nut.

6. Reinstall the processor RTM into the chassis, and secure the retaining screws.

Figure 2: CompactFlash Card on the RTM

IIIIIIIIIIIIIIIIIIIIIIIIIIIII

CompactFlash card

CompactFlash

locking screw

g015386

Install a PMC Module

The PMC module is mounted onto the processor module and can be installed or replaced

in the field. Figure 3 on page 11 displays the location of the PMC module.

CTP2000 Series Platform Quick Start

Other manuals for Juniper CTP2000 Series