7. From the back of the processor module, use the four Phillips head screws to secure
the two PMC standoff posts and PMC front assembly to the processor module.
8. Reinstall the processor.
Install SFPs
This section describes how to install small form-factor pluggable transceivers (SFPs)
on interface modules that support these devices. In the current release, the
CTP-FX2000GE-UPG supports SFPs.
You can replace the SFPs without disabling the interfaces or removing the module from
the device.
To install SFPs:
1. Ground yourself by using an antistatic wrist strap or other device, and connect it to
an ESD grounding jack.
2. Identify the following items on the SFP (Figure 4 on page 12):
•
The connection circuitry on the base
•
The cable connectors on the front (which are protected by a dust cover)
Figure 4: Representative SFP
CAUTION: Be sure to position the SFP correctly before you install it.
3. Hold the SFP so that:
•
The connection circuitry is adjacent to the module's faceplate.
•
The cable connectors are visible when you install the SFP.
4. Slide the SFP as far as you can into the module until the SFP clicks into place.
Copyright © 2019, Juniper Networks, Inc.12
CTP2000 Series Platform Quick Start
To Next Page
Loading...
