Juniper EX4400 - Page 158

The front mounng bracket assembly is made up of a side rail to which an L-shaped bracket is
aached.
• Flat head 4x6-mm Phillips screws to aach the front mounng bracket assembly to the chassis—12
(provided with the four-post rack mount kit)
• Rear mounng brackets—2 (provided with the four-post rack mount kit)
• Covers for the empty extension module slot and the empty power supply slot—provided with the
switch
You can also mount an EX4400 switch:
• In a recessed posion inside a 19-in. four-post rack by using the recessed-mounng brackets
provided with a separately orderable four-post rack mount kit.
• On a two-post rack or on two posts of a 19-in. four-post rack by using the two-post mounng
brackets and screws provided with the switch.
• On a desk or other level surface by using the rubber feet provided with the switch.
• On a wall by using a separately orderable wall mount kit.
To know the part numbers for ordering the separately orderable mounng kits, see the EX4400
Switches Datasheet.
NOTE: One person must be available to li the switch while another person secures the switch
to the rack.
CAUTION: If you are mounng mulple units on a rack, mount the heaviest unit at the
boom of the rack, and then mount the other units from the boom of the rack to the
top in decreasing order of the weight of the units.
To mount an EX4400 switch ush with the front posts of a 19-in. four-post rack:
1. Place the switch on a at, stable surface.
2. Wrap and fasten one end of the ESD wrist strap around your bare wrist, and connect the other end
of the strap to a site ESD point.
3. Align the front mounng bracket assembly (provided with the four-post rack mount kit) along the
side panel of the switch such that the front of the bracket assembly is ush with the front panel of
the switch chassis.
150