Juniper EX4400 - Page 161

Ensure that you have the following parts and tools available:
• Number 2 Phillips (+) screwdriver—not provided
• Eight screws to secure the mounng brackets to the rack—not provided
• An ESD grounding strap—not provided
• Front mounng bracket assembly to mount the switch ush with the front posts of a rack—2
(provided with the four-post rack mount kit)
The front mounng bracket assembly is made up of a side rail to which an L-shaped bracket is
aached.
• Flat head 4x6-mm Phillips screws to aach the front mounng bracket assembly to the chassis—12
(provided with the four-post rack mount kit)
• Rear mounng brackets with blades—2 (provided with the four-post rack mount kit)
• Recessed-mounng brackets to mount the switch in a recessed posion from the front posts of a
rack—2 (provided with the four-post rack mount kit)
• Flat head 4-40 Phillips screws to aach the recessed-mounng brackets to the side rails of the
bracket assembly—6 (provided with the four-post rack mount kit)
• Covers for the empty extension module slot and the empty power supply slot—provided with the
switch
You can also mount an EX4400 switch:
• Flush with the front posts of a 19-in. four-post rack by using a separately orderable four-post rack
mount kit.
• On a two-post rack or on two posts of a 19-in. four-post rack by using the two-post mounng
brackets and screws provided with the switch.
• On a desk or other level surface by using the rubber feet provided with the switch.
• On a wall by using a separately orderable wall mount kit.
To know the part numbers for ordering the separately orderable mounng kits, see the EX4400
Switches Datasheet.
NOTE: One person must be available to li the switch while another person secures the switch
to the rack.
153