Figure 97: Measurements for Mounng an EX4400 Switch on a Wall
If the mounng screws are inserted in a wall board with no stud behind it, you must use dry wall
anchors rated to support 66 lb (30 kg). Insert the screws into wall studs wherever possible to provide
added support for the chassis.
Drive the screws only part way in, leaving about 1/4 in. (6 mm) distance between the head of the
screw and the wall. Use the screwdriver to drive the screws in.
5. Grasp each side of the switch, li the switch, and hang the brackets from the mounng screws (see
Figure 98 on page 161).
160
To Next Page
Loading...
