Juniper EX4400 - Page 183

NOTE: While using Finisar AOC SFP+ opcal module with the QFX5130-48C switch, you
may need to pull the module upwards to pull out the module smoothly from the cage.
NOTE: "
Figure 108: Install a Transceiver
1—
Ejector lever
Install a QSFP28 Transceiver
Before you install a transceiver in a device, ensure that you have taken the necessary precauons for
safe handling of lasers (see Laser and LED Safety Guidelines and Warnings ).
Ensure that you have a rubber safety cap available to cover the transceiver.
The transceivers for Juniper Networks devices are hot-removable and hot-insertable eld-replaceable
units (FRUs). You can remove and replace the transceivers without powering o the device or disrupng
the device funcons.
NOTE: Aer you insert a transceiver or aer you change the media-type conguraon, wait for
6 seconds for the interface to display operaonal commands.
175