Juniper EX4400 - Page 191

13. (Oponal) Congure the IP address of a backup router, which is used only while the roung
protocol is not running.
[edit]
root# set system backup-router address
14. Congure the IP address of a DNS server.
[edit]
root# set system name-server address
15. (Oponal) Congure the stac routes to remote subnets with access to the management port.
Access to the management port is limited to the local subnet.
[edit]
root# set routing-options static route remote-subnet next-hop destination-IP retain no-
readvertise
16. (Oponal) Congure the stac routes to remote prexes with access to the management port.
[edit]
root# set routing-options static route remote-prefix next-hop destination-IP retain no-
readvertise
17. Congure the SSH service.
[edit]
root# set system services ssh root-login allow
18. Congure in-band management or out-of-band management:
• With in-band management, you can congure a network port interface as the management
interface and connect it to the management device. In this scenario, you can do either of the
following:
• Use the automacally created VLAN named default for management of all data interfaces as
members of the default VLAN. Specify the management IP address and the default gateway.
• Create a new management VLAN. Specify the VLAN name, VLAN ID, management IP
address, and default gateway. Select the ports that must be part of this VLAN.
183