Juniper EX4400 - Page 192

• With out-of-band management, you use a dedicated management channel to connect to the
management device. Specify the IP address and gateway of the management interface. Use this
IP address to connect to the switch.
19. (Oponal) Specify the SNMP read community, locaon, and contact to congure SNMP parameters.
20. (Oponal) Specify the system date and me. Select the me zone from the list. The congured
parameters are displayed.
21. Enter yes to commit the conguraon. The conguraon is commied as the acve conguraon
for the switch.
22. (Oponal) Display the conguraon to verify that it is correct.
23. (Oponal) Congure addional properes by adding the necessary conguraon statements.
24. Commit the conguraon to acvate it on the switch.
[edit]
root# commit
25. When you have nished conguring the switch, exit conguraon mode.
[edit]
root@switch# exit
root@switch>
You can now log in by using the CLI and connue conguring the switch.
To connect and congure an EX4400 switch by using the J-Web interface, see Connecng and
Conguring an EX Series Switch (J-Web Procedure).
EX4400 Default Conguraon
Each EX Series switch is programmed with a factory-default conguraon that contains the values set
for each conguraon parameter when the switch is shipped. The default conguraon le sets values
for system parameters such as syslog and commit, congures Ethernet switching on all interfaces, enables
IGMP snooping, and enables the LLDP and RSTP protocols.
NOTE:
• The factory-default conguraon le has more interfaces for models that have more ports.
184