Juniper EX4400 - Page 43

Figure 22: Components on the Front Panel of an EX4400-48F Switch
1—
SFP ports
5—
Port mode LEDs (labeled SPD, DX, and EN)
2—
SFP+ ports
6—
Factory reset/mode buon
3—
USB-C console port
7—
Extension module slot
4—
Chassis status LEDs (labeled SYS, ALM, MST,
and CLD)
NOTE: We enabled the CLD LED feature in Junos OS Release 21.2R1.
EX4400-48F model supports 550-W AC or DC power supplies. You must not install AC and DC power
supplies in the same chassis.
Figure 23 on page 35 shows the components on the rear panel of an EX4400-48F switch with an AC
power supply.
Figure 23: Components on the Rear Panel of an EX4400-48F Switch with an AC Power Supply
1—
Serial number ID label
9—
Empty slot for power supply
2—
Console port (labeled CON)
10—
Power supply rang label
3—
Management port (labeled MGMT)
11—
ESD point
4—
USB-A port
12—
QSFP28 port LEDs
5—
QSFP28 ports
13—
Reset buon
35