Juniper EX4400 - Page 61

Figure 37: Components on the Front Panel of an EX4400-24MP Switch
1—
100-Mbps/1-Gbps/2.5-Gbps/5-Gbps/10-
Gbps RJ-45 ports. These ports support PoE-
bt.
4—
Port mode LEDs (labeled SPD, DX, EN, and
POE)
2—
USB-C console port
5—
Factory reset/mode buon
3—
Chassis status LEDs (labeled SYS, ALM, MST,
and CLD)
6—
Extension module slot
Figure 38 on page 53 shows the components on the rear panel of an EX4400-24MP switch. This
model supports 1600-W AC power supply if you have Junos OS Release 22.3R1 or later installed. We
ship the switch with one 1050-W power supply. You can order the addional power supply separately.
You must not install dierent models of power supplies in the same chassis.
Figure 38: Components on the Rear Panel of an EX4400-24MP Switch
1—
Serial number ID label
9—
Empty slot for power supply
2—
Console port (labeled CON)
10—
Power supply rang label
3—
Management port (labeled MGMT)
11—
ESD point
4—
USB-A port
12—
QSFP28 port LEDs
5—
QSFP28 ports
13—
Reset buon
6—
CLEI code label
14—
Protecve earthing terminal
7—
Fan module
15—
Claim code label
8—
1050-W AC power supply
53