Juniper EX4400 - Page 65

Figure 40: Rear View of an EX4400-48MP Switch
Figure 41 on page 57 shows the components on the front panel of an EX4400-48MP switch.
Figure 41: Components on the Front Panel of an EX4400-48MP Switch
1—
100-Mbps/1-Gbps/2.5-Gbps RJ-45 ports.
These ports support PoE-bt.
5—
Port mode LEDs (labeled SPD, DX, EN, and
POE)
2—
100-Mbps/1-Gbps/2.5-Gbps/5-Gbps/10-
Gbps RJ-45 ports. These ports support PoE-
bt.
6—
Factory reset/mode buon
3—
USB-C console port
7—
Extension module slot
4—
Chassis status LEDs (labeled SYS, ALM, MST,
and CLD)
Figure 42 on page 57 shows the components on the rear panel of an EX4400-48MP switch. This
model supports only 1600-W AC power supply.
Figure 42: Components on the Rear Panel of an EX4400-48MP Switch
1—
Serial number ID label
9—
Empty slot for power supply
57