Juniper EX4400 - Page 71

You can mount an EX4400 switch:
• On a two-post rack or on two posts of a 19-in. four-post rack by using the two-post mounng
brackets provided with the switch.
• Flush with the front posts of a 19-in. four-post rack by using a separately orderable four-post rack
mount kit.
• In a recessed posion inside a 19-in. four-post rack by using the recessed-mounng brackets
provided with a separately orderable four-post rack mount kit.
• On a desk or other level surface by using the rubber feet provided with the switch.
• On a wall by using a separately orderable wall mount kit.
To know the part numbers for ordering the separately orderable mounng kits, see the EX4400
Switches Datasheet.
See "EX4400 Models and Specicaons" on page 16 to know more about the EX4400 models and their
specicaons.
Chassis Status LEDs on EX4400 Switches
Each EX4400 switch has four chassis status LEDs (labeled SYS, ALM, MST, and CLD) on the right-hand
side of the front panel (see Figure 44 on page 63).
For informaon on the blink paerns of the CLD LED, which provide the cloud connecon status of the
switch, see Cloud Ready LED Blink Paerns, or see Cloud Connecon Process, to understand how the
cloud connecon works.
Figure 44: Chassis Status LEDs in EX4400 Switches
1—
Chassis status LEDs
63