show security flow session
Syntax show security flow session
[filter ] [brief | extensive | summary ]
Release Information Command introduced in Junos OS Release 8.5. Support for filter and view options added
in Junos OS Release 10.2. Application firewall, dynamic application, and logical system
filters added in Junos OS Release 11.2. Policy ID filter added in Junos OS Release
12.3X48-D10.
Description Display information about all currently active security sessions on the device.
Options filter—Filter the display by the specified criteria.•
The following filters reduce the display to those sessions that match the criteria
specified by the filter. Refer to the specific show command for examples of the filtered
output.
application—Predefined application name
application-firewall—Application firewall enabled
application-firewall-rule-set—Application firewall enabled with the specified rule set
application-traffic-control—Application traffic control session
application-traffic-control-rule-set—Application traffic control rule set name and rule
name
destination-port—Destination port
destination-prefix—Destination IP prefix or address
dynamic-application—Dynamic application
dynamic-application-group—Dynamic application
encrypted—Encrypted traffic
extensive—Display detailed output
family—Display session by family
idp—IDP enabled sessions
interface—Name of incoming or outgoing interface
logical-system (all | logical-system-name)—Name of a specific logical system or all to
display all logical systems
nat—Display sessions with network address translation
policy-id—Display session information based on policy ID; the range is 1 through
4,294,967,295
109Copyright © 2016, Juniper Networks, Inc.
Chapter 12: Operational Commands
To Next Page
Loading...
Need help?
General
