Juniper Junos OS User Manual

NOTE: To access the device through SSH and Telnet, you need to set up
a root password. For more details, see Connecting Your Branch SRX Series
for the First Time.
Related
Documentation
Understanding Factory Default Configuration Settings of an SRX210 on page 7•
• Configuring a Hostname to Identify a Branch SRX Series Services Gateway in Your
Network on page 20
Mandatory Settings to Configure the Branch SRX Series
Table 6 on page 18 provides the details on configuration settings that you need to enter
when configuring the device for the first time.
Table 6: Settings Used to Configure the SRX210
DetailsSettings
Record the login name of the services gateway
administrator. Default is root, which you must change
during your first J-Web session.
Administrator Username
Record the password for this administrator account.Administrator Password
Record the name of your SRX210 to identify itself on
your network.
Hostname
Network security often depends on knowing the exact
time, when a specific event occurs. If you do not have
access to a private NTP server, you can enter the name
or IP address of a public NTP server. For information
about public time servers, see
http://tf.nist.gov/tf-cgi/servers.cgi.
Network Time Protocol (NTP) Server
Record the time zone to be used by your services
gateway.
Time Zone
Your Internet Service Provider might use the Dynamic
Host Configuration Protocol (DHCP) to assign an IP
address and routing information to your services
gateway.
NOTE: The DHCP client configuration is by default
enabled on port 0/0 (ge-0/0/0).
NOTE: If your ISP does not support DHCP, you should
ask your ISP what settings (IP address, default gateway,
DNS server) to use to configure the WAN interface on
your services gateway.
IP address assignment
Copyright © 2016, Juniper Networks, Inc.18
Getting Started Guide for Branch SRX Series

Juniper Junos OS Specifications

General

Brand	Juniper
Model	Junos OS
Category	Network Hardware
Language	English