You can install any transceiver supported by the PIC. For information about installing and
removing transceivers, see the PIC and Transceiver Installation Instructions.
■
Duplex LC/PC connector (Rx and Tx)
■
Optical interface support—See Table 33 on page 105, Table 34 on page 106, and
Table 35 on page 106
NOTE: To extend the life of the laser, when a PIC is not being actively used with any valid
links, take the PIC offline until you are ready to establish a link to another device. For
information about taking a PIC offline, see the request chassis pic offline command in the
JUNOS System Basics and Services Command Reference.
Cables and connectors
One tricolor per port:
■
Off—Not enabled
■
Green—Online with no alarms or failures
■
Amber—Online with alarms for remote failures
■
Red—Active with a local alarm; router has detected a failure
LEDs
104 ■ SONET/SDH OC48/STM16 (Multi-Rate) PIC with SFP
M120 Internet Router PIC Guide
To Next Page
Loading...
