EasyManua.ls Logo

Juniper M120 - M120 Cabinet Airflow Requirements; M120 Rack Mounting Requirements

Juniper M120
116 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SONET/SDH OC3c/STM1 PIC
JUNOS 8.0R2 and later (Type 1)
NOTE: Although the illustration shows a multimode PIC, a multimode PIC and a single-mode
intermediate reach PIC are both supported.
NOTE: This PIC is not supported in JUNOS Release 8.1R1.
Software release
Four OC3 ports
Power requirement: 0.49 A @ 48 V (23.7 W)
Description
Multiplexing and demultiplexing
Rate policing on input
Rate shaping on output
Packet buffering, Layer 2 parsing
Hardware features
SONET/SDH framing
Link aggregation
Alarm and event counting and detection
Dual-router automatic protection switching (APS)
Multiprotocol Label Switching (MPLS) fast reroute
Encapsulations:
High-Level Data Link Control (HDLC)
Frame Relay
Circuit cross-connect (CCC)
Translational cross-connect (TCC)
Point-to-Point Protocol (PPP)
Software features
SONET/SDH OC3c/STM1 PIC 83
SONET/SDH OC3c/STM1 PIC

Other manuals for Juniper M120

Related product manuals