Juniper M120 - Tunnel Services PIC

Tunnel Services PIC
■
JUNOS 8.0R2 and later (Type 1, Type 2, and Type 3)
NOTE: This PIC is not supported in JUNOS Release 8.1R1.
Software release
■
Power requirement: 0.07 A @ 48 V (3.4 W)Description
■
Loopback function that encapsulates and de-encapsulates packets
■
OC12/STM4 tunneling bandwidth on FPC1; OC48/STM16 tunneling bandwidth on FPC2;
OC192/STM64 tunneling bandwidth on FPC3
Hardware features
For a list of the software features available for services PICs, see the JUNOS Services Interfaces
Configuration Guide.
■
IP-IP unicast tunneling
■
GRE unicast tunneling
■
PIM sparse mode unicast tunneling
Software features
One tricolor:
■
Off—Not enabled
■
Green—Online with no alarms or failures
■
Amber—Online with alarms for remote failures
■
Red—Active with a local alarm; router has detected a failure
LEDs
114 ■ Tunnel Services PIC
M120 Internet Router PIC Guide