Juniper M120 - SONET;SDH Oc12 C;Stm4 PIC

SONET/SDH OC12c/STM4 PIC
■
JUNOS 8.0R2 and later
NOTE: This PIC is not supported in JUNOS Release 8.1R1.
Software release
■
One OC12 port
■
Power requirement: 0.23 A @ 48 V (10.8 W)
Description
■
Multiplexing and demultiplexing
■
Rate policing on input
■
Rate shaping on output
■
Packet buffering, Layer 2 parsing
Hardware features
■
SONET/SDH framing
■
Link aggregation
■
Alarm and event counting and detection
■
Dual-router automatic protection switching (APS)
■
Multiprotocol Label Switching (MPLS) fast reroute
■
Encapsulations:
■
High-Level Data Link Control (HDLC)
■
Frame Relay
■
Circuit cross-connect (CCC)
■
Translational cross-connect (TCC)
■
Point-to-Point Protocol (PPP)
Software features
■
Duplex SC/PC connector (Rx and Tx)
■
Optical interface support—See Table 28 on page 93
NOTE: To extend the life of the laser, when a PIC is not being actively used with any valid
links, take the PIC offline until you are ready to establish a link to another device. For
information about taking a PIC offline, see the request chassis pic offline command in the
JUNOS System Basics and Services Command Reference.
Cables and connectors
SONET/SDH OC12c/STM4 PIC ■ 91
SONET/SDH OC12c/STM4 PIC