EasyManua.ls Logo

Juniper M120 - FPC Components and Terminology

Juniper M120
116 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Quality of service (QoS) per port: weighted round-robin (WRR), random early detection
(RED), weighted random early detection (WRED)
Simple Network Management Protocol (SNMP): E3 MIB, QoS MIB
Input policing and output shaping
Provider-side rate limiting
Full data link connection identifier (DLCI) range with sparse channel numbering
Per-DLCI queues with weighted deficit round-robin and strict priority
Encapsulations:
High-Level Data Link Control (HDLC)
Frame Relay
Circuit cross-connect (CCC)
Translational cross-connect (TCC)
Point-to-Point Protocol (PPP)
JUNOS Release 7.0 or later is required to configure graceful Routing Engine switchover
(GRES).
Software features
Standard E3 BNC coaxial cable interfacesCables and connectors
One tricolor per port:
OffNot enabled
GreenOnline with no alarms or failures
AmberOnline with alarms for remote failures
RedActive with a local alarm; router has detected a failure
LEDs
Alarm indication signal (AIS)
Equipment failure (does not affect service)
Frame error
Line code violation
Loss of signal (LOS)
Out of frame (OOF)
Yellow alarm bit (A-bit) disagreements
Alarms, errors, and
events
Layer 2 per-queue packet and byte countersInstrumentation
(counters)
E3 IQ PIC 53
E3 IQ PIC

Other manuals for Juniper M120

Related product manuals