Ch 8 Barcode Scanner 75
While the Barcode Connector utility loads, a progress bar is
displayed, then the main Barcode Connector utility screen
appears as shown below:
Two main functions are accessed from here:
1. Barcode Setup – Use the setup screens to congure the
seings of the barcode hardware and Barcode Connector
utility.
2. Power Down Barcode and Exit – This function completely
shuts down the barcode scanner. You may want to do
this to prevent accidental triggering of a scan sequence.
Otherwise, we recommend that you leave it powered on.
The barcode is congured to enter a sleep state when it is
inactive and consumes about 8mW of power when it is in
this state.
To minimize the Barcode Connector utility press the X in the
boom right corner of the display.
To Next Page
Loading...
