Juniper Mesa - Page 80

80 Mesa Rugged Notepad Owner’s Manual
The 1D Code Types tab has the following functions:
 Inverse 1D – Enable/disable inverse 1D bar codes or select
Auto Detect.
 Enable/disable the 1D code types listed.
 Select the Options function to congure 1D code type
specic seings. New tabs are shown across the top for Code
39, Code 128/Code 93/Discrete, UPC/EAN 1, UPC/EAN 2,
Interleaved GS1 DataBar, MSI Plessey, Codabar/Code 11,
and Matrix 2 of 5. Depending on which 1D barcodes you are
going to read, you should review the options and congure
them for your needs. (Sample 1D bacodes are shown at the
end of this chapter.) For example, below is the tab for code
type Code 39:
Set Length: This option allows you to specify the length of
the barcodes you want to read. This could be useful if you
know that all valid barcodes will be a specic length or a
range of lengths.
 There are four ways to specify the allowed barcode lengths.
Let A refer to the rst length eld and B refer to the second
length eld.