Figure 54: Lifting the MX10008 Without Using a Mechanical Lift
4. Carefully slide the router onto the base and rear mounting brackets until the chassis flanges contact
the rack rails. The mounting brackets ensure that the holes in the flanges align with the holes in the
rack rails. See Figure 55 on page 150.
5. Attach the chassis to the rack by installing a mounting screw through the open flange holes and rack,
starting from the bottom.
6. Visually inspect the alignment of the chassis. If the chassis is installed properly in the rack, all the
mounting screws on one side of the rack are aligned with the mounting screws on the opposite side
and the router is level.
7. After ensuring that the router is aligned properly, tighten the screws.
149
To Next Page
Loading...
