5. Unscrew the captive screw counterclockwise by using the Phillips (+) screwdriver, number 1. See
Figure 102 on page 207 and Figure 103 on page 207.
Figure 102: Removing a JNP10K-PWR-AC2 from an MX10008 Chassis
Figure 103: Removing a JNP10K-PWR-AC2 from an MX10016 Chassis
6. Rotate the captive screw away from the faceplate of the power supply to release the latch.
7. Put on your heat protective gloves before removing the power supply from the chassis.
207
To Next Page
Loading...
