Figure 106: Removing the Power Supply Cover Panel on an MX10008
Figure 107: Removing the Power Supply Cover Panel on an MX10016
3. Taking care not to touch power supply connections, remove the power supply from its bag.
4. Peel back and remove the protective plastic wrap that covers all four sides of the power supply.
5. Ensure the power switch is set to the standby (O) position. This switch turns off the output voltage; it
does not interrupt input power.
6. Unscrew the captive screw in the counterclockwise direction by using the Phillips (+) screwdriver,
number 1.
7. Rotate the captive screw away from the faceplate of the power supply to release the latch.
211
To Next Page
Loading...
