NOTE: Ensure that the ejector is fully open to avoid scratching the chassis.
g051046
YES
Ejector fully open
NO
Ejector closed
19. Route INP1 cables to a power source and INP2 to another power source. The JNP10K-PWR-DC shares
power, so if power dips on one input, the power supply is able to load balance internally. See
Figure 124 on page 228 and Figure 125 on page 229.
Figure 124: Proper Load Balancing for JNP10K-PWR-DC Power Cables on MX10008
228
To Next Page
Loading...
