CAUTION: The SFB surface and handles may be hot. Allow a few minutes for the
surface and handles to cool by pulling out the SFB halfway out of the chassis. Wear
proper protective, heat-resistant gloves while removing an SFB.
Figure 146: Removing the SFB from an MX10008 Chassis
9. Support the SFB as you rotate the SFB 90 degrees and place it on the antistatic mat with the printed
circuit board facing upward. Be careful not to bump or handle the SFB by the connectors. If you do
not have an antistatic mat, have another person help you slide the electrostatic bag over the SFB before
placing it on the stable surface. See Figure 147 on page 251.
CAUTION: Do not stack hardware components on top of one another after you
remove them. Place each component on an antistatic mat resting on a stable, flat
surface.
250
To Next Page
Loading...
